The magnetic structure of TbNiSiD1.78

TbNiSiD_1.78 has been studied by powder neutron diffraction below 100 K. The compound takes the hexagonal room temperature structure at 100 and 50 K (P6₃/mmc). At 2 K, below the antiferromagnetic ordering temperature of 10 K, there is a small orthorhombic distortion of the lattice. The refined unit-cell dimensions at 2 K (space group Pnma) are a=7.9505(2), b=4.02502(14), c=6.9823(2) Å. The magnetic moments of Tb are 8.71(6) μ_B, and are ordered antiferromagnetically along a.     

离子注入中污染的产生及防护

本文概述了离子注入过程中污染产生的原因和防止污染的措施，特别强调了对微粒污染和金属污染的防护以满足ＵＬＳＩ加工对离子注入的要求。     

Sulfated zirconia catalysts: Are Brønsted acid sites the source of the activity?

The thermal decomposition products of pyridinium sulfate differ from those of pyridinium sulfate supported on zirconia which in turn differs from that of pyridine adsorbed on a sulfated zirconia. Unsupported pyridinium sulfate decomposes to produce pyridine and sulfuric acid, and these subsequently react to produce oxides of carbon and sulfur. Zirconia that is sulfated and then exposed to pyridine does not release detectable amount of pyridine during heating in an inert gas; rather the pyridine undergoes oxidation reduction reactions simultaneously to release CO₂ and sulfur compounds. Pyridinium sulfate supported on zirconia decomposes upon heating to release pyridine and sulfuric acid, which reacts with the zirconia. The desorption of pyridine in one case and only CO₂/SO_x in the other case suggests that sulfated zirconia does not contain Brønsted acidity that can form pyridinium sulfate.     

Synthesis of heterocyclic metal complexes and their evaluation as marine antifoulants

4-Amino-3-thio-1,24-triazolidine (L₁) and 4-amino-5-thio-1,3,4-thiadiazole (L_II) as well as their metal complexes of the general formulae ML_I·2H₂O and ML_IICl (M; Pb(II), Cd(II) and Zn(II)) were prepared. With Sn(II), we obtained Sn(L_I)₂·2H₂O and SnL_IICl, respectively. The structures of the compounds were identified through elemental analysis, and IR and UV spectra measurements, in addition to thermal analysis in case of the metal complexes. The antifouling properties of the compounds were tested by their incorporation into paint formulations which were applied to PVC substrates and tested in water from Alexandria western harbour. When the compounds were added at 17·5% by volume, the coated panels were fouled after 3 months of immersion. The addition of 6·7% by volume of tributyltin oxide to 15·8% of the prepared compounds in one formulation elevated the paint efficiency and prevented fouling for 11 months. Paint containing solely tributyltin oxide at the same concentration was inactive against algae.     

聚合物载体－稀土金属络合物的研究 ⅩⅢ．聚［苯乙烯－甲基丙烯酸β（甲基亚硫酰基）乙酯］的结构与其稀土金属络合物催化丁二烯聚合的活性

从测得的竞聚率计算了单体链节在聚［苯乙烯－甲基丙烯酸β（甲基亚硫酰基）乙酯］（ＰＳＭ）中的序列分布。苯乙烯（Ｓ）或甲基丙烯酸β（甲基亚硫酰基）乙酯（Ｍ）的长序列的概率随着ＰＳＭ中相应单体含量的增加而增加。对于Ｓ和Ｍ摩尔分数大致相等的ＰＳＭ，单体链节的长序列分布函数值相接近。用与此结构相近的ＰＳＭ合成的稀土金属络合物，其催化活性不佳。在Ｍ短序列分布和Ｓ长序列分布较高的情况下，络合物的催化活性最好。所得聚丁二烯的微观结构与ＰＳＭ中单体单元的分布无关。     

铜铅锌银多金属矿湿法分离新工艺

依据不同金属硫化物氧化分解电位的差异 ,针对某含铜、铅、锌、银复杂多金属硫化矿的难选冶特性 ,对浮选获得的混合精矿采取在线控制浸出过程氧化还原电位的方法 ,分步选择性氯化浸出各有价元素 ,并辅之以沉淀、置换、萃取等工艺 ,使有价金属以较高的回收率得到了有效的分离提取 ,在各工序最佳条件下 ,Cu、Pb、Zn、Ag各金属的浸出率均大于 99 0 % ,元素硫的回收率大于 76%     

碱金属离子对PtSn/Al2O3催化剂丙烷脱氢活性的影响

用吡啶吸附－红外光谱和热重法研究了Li^ 、Na^ 、K^ 碱金属离子对负载型PtSn/Al2O3催化剂在丙烷脱氢中活性的影响。结果表明，碱金属离子对催化剂表面酸性有调变作用，提高了PtSn/Al2O3催化剂脱氢选择性，引入适量的Li^ 和Na^ 可减少催化剂的积碳量，改善催化剂的稳定性，提高丙烷转化率和丙烯收率；而引入K^ 可减少催化剂的积碳量，但丙烷转化率和丙烯收率大幅下降。     

Chemical leaching and magnetic properties of non-equilibrium Al(Co–Cu) powders produced by rod milling

We report upon the chemical leaching and magnetic properties of nanoscale crystalline Al_0.6(Co₂₅Cu₇₅)_0.4 alloy powders produced by rod milling. X-Ray diffractometry (XRD), transmission electron microscopy, differential scanning calorimetry, vibrating sample magnetometry, and superconducting quantum interference device magnetometry were used to characterize the as-milled and leached specimens. After 400 h of milling, only the b.c.c. phase of the intermetallic compound γ-Al_3.892Cu_6.10808 was detected by XRD. After annealing the leached specimen at 600 °C for 1 h, the nanoscale crystalline phase was transformed into the f.c.c. Cu phase, and this was accompanied by a change in the magnetic properties. The peaks of the magnetization shifted towards lower temperature with increasing external field. The temperature behavior at T_f (45 K) for direct current (d.c.) magnetic susceptibility measurements was quite different for field cooling and zero-field cooling. After cooling the leached specimen from 800 °C, magnetization increased gradually.     

全球趋向统一的《粉末冶金零件材料规范》

评述了ISO 5 75 5“烧结金属材料—规范”和美国MPIF标准 35的变迁和趋向统一。阐述了“最小强度值”的意义。说明了我国粉末冶金结构零件材料标准的现状     

高热流密度电加热元件

本文论述了用于液态金属钠热工水力性能研究的高热流密度模拟电加热元件的结构特点、材料选择、热电偶设置及其他与棒束传热实验研究有关的问题。